Módszer of megítélés a minőség motor by multiméter
Vannak vannak háromfázisú motorok és egyfázisú motorok, és egyfázisú motorok van három vonal és hat vonal.
háromfázisú motor
Six taps for three-phase winding of phase motor. Let's first remove the connecting piece connecting the motor terminal. Measure the beginning and end of each phase winding with a multimeter to see if it is on or off. Then use a multimeter to measure the resistance between each two-phase winding, at least greater than 0.5 megohm, and the greater the better. Finally, measure the insulation resistance between each phase winding and the motor shell, which should also be infinite. In this way, the quality of three-phase motor can be judged basically.
Egyfázisú motor három vezetékekkel
A egyirányú motor van csak kettő tekercselés, a indítás tekercselés és a futás tekercselés. egy a három vezeték van saját vezetékük, hogy van, egy vég a kétfázisú tekercselés van összekötött összeconnected. A Másik Kettő Vagy A Egyéb Csapok A Kétfázis Tekercselés.
A ellenállás között a kettő csapok kell legyen maximum és egyenlő a az összeg a ellenállás értékek a a kettő tekercsek.
Of course, mi van van mérni a ellenállás között a tekercs és a burkolat to látni ha it volt volt törött le. Of course, the greater the resistance, the better, and the lowest is the same, not less than 0.5 megohm.
6-}wire egyfázisú motor
There are six lines, in fact, two lines (Z1, Z2) are centrifugal switch lines. This kind of motor also has hat terminálok, so its csatlakozó darab kell legyen eltávolítsa. Remove the the dencapacitor, and then measure the end of the two-phase winding and the resistance between the two-phase windings ill. The method is the same as that of three-phase motor.
Használat multiméter nak nek bíró a minőség a motor csak csak be a előzetes ítélet . A szigetelés ellenállás között tekercsek és a szigetelés ellenállás minden fázis tekercs a föld kell mérni by megger be be több pontos.
Also, the short circuit between turns of winding can't be measured. We can only guess whether there is a short circuit between turns by comparison. For example, the winding structure of one phase is much smaller than that of the other two phases, so we can suspect that it has turn-to-turn short circuit.
